[ad_1]
After the steam solenoid valve is installed, it is necessary to enter the medium for several experiments, and it can be put into official use after confirming that it is normal.
The dirt on the inside and outside of the large valve and the suction and joint surfaces should be cleaned regularly, and be careful not to damage the sealing surface.
When the steam solenoid valve is not used for a long time, the manual valve in front of the valve should be closed. When it is reactivated, the steam solenoid valve should be drained of condensed water, and the steam solenoid valve should be tested several times before it can be put into use after the switch is normal.
When the steam solenoid valve is removed from the pipeline, the internal parts should be wiped clean and stored with compressed air.
When used for a long time, if the seal between the piston and the valve seat is not good, the sealing surface of the piston can be re-ground, and then ground with the valve seat.
When working, pay attention to the pressure gauges before and after the valve. It is required that the working pressure should not exceed the rated pressure, and the working pressure difference must be within the rated pressure difference range. When the working pressure exceeds the rated pressure or the working pressure difference exceeds the rated pressure difference, the steam solenoid valve should be stopped, and the front and rear manual valves should be closed to avoid explosion and leakage of the steam solenoid valve.
[ad_2]
